ScannerCommands

Enter a freely selectable ASCII character string that is sent to the barcode scanner when the connection is established.

Handshake.

Select a handshake for the serial device:

None: No control element is used for the handshake.

XOnXOff: The XON/XOFF software control protocol is used.

RequestToSend: Request-to-Send (RTS) hardware flow control is used.

RequestToSendXOnXOff: Both the Request-to-Send (RTS) hardware flow control and the XON/XOFF software control protocol are used.

Default value: None

StopBits

Select Stop Bits for data transfer (None, One, Two, OnePointFive) for the serial device.

Default value: One/None

The value selected in Nexeed Rework Control must match the value configured on the hardware side.

DataBits

Enter DataBits for the serial device (4, 5, 6, 7, 8).

Default value: 8

Parity

Select the data transmission parity (None, Odd, Even, Mark, Space) for the serial device.

Default value: None

Baud

Enter the baud rate for the serial device (75, 110, 134, 150, 300, 600, 1200, 1800, 2400, 4800, 7200, 9600, 14400, 19200, 38400, 57600, 115200, 128000).

Default value: 9600

COM

Enter the COM port for the serial device.

Default value: Attachment 1

Enter only a number, not a character string.

ReReadDelayMs

Enter the timeout for reading the data of the serial device (in milliseconds).

Default value: 100

Active

Specify the connection to the hardware.

Default value:

Shared

Specify whether the device can also be used by other applications.

Default value:

Jobs

Specify whether optional workflows are executed cyclically in HAL.

Default value:

MultipleInstancesAllowed

Specify whether multiple instances of Nexeed Rework Control can be opened at the same time.

Default value: