Distribution Overview — Adding Commands to a Distribution

Distributions are used to bundle several commands and to execute them in a defined sequence during a roll-out. These commands can be divided into software artifacts and custom commands, depending on the device type selected for the distribution. This chapter shows how these commands are assigned to a distribution.

1. Click the action button to open the selection field in which new commands can be assigned to the distribution.

   

2. Open the Add Artifacts Wizard by clicking on Add Artifacts. Software artifacts can be selected here.

   

3. After selecting the artifacts, click Next to open the summary of the selected artifacts. In the summary, the artifacts can be deleted again, or their order can be changed.

   

4. Assign the new artifacts to the distribution in the specified sequence by clicking Add Artifacts.

   

The artifacts are assigned to the distribution.