Configure Task Details for a Corrective Task

The task details for a corrective task of a device and that of a tool differ only in the Device and Tool field.

Prerequisite

User or Administrator role

Procedure

Call up the Maintenance > Machine maintenance menu.
Or:

Call up the Maintenance > Tool maintenance menu.
Select corrective task.
Use to deactivate or to activate notifications about changes to the status of the task.
If the status of a task changes, a notification is sent to the Nexeed Notification Service module. The Nexeed Notification Service module then processes the notification further.
Introduction to the Nexeed Notification Service Module
Enter name of the task.
Enter the Description.
If the device has failed, activate the Failure Occurred? checkbox.
Breakdown occurred? is only displayed for devices.
Select Priority.
Select Malfunction start and Malfunction end.
Select Resolving group.
Select the user in the Responsible field.
Confirm details with Save.

The corrective task details are configured.

To appraise the corrective task, continue with Carry Out Appraisal of a Corrective Task.
To add further attachments to a corrective task, continue withManage attachments for a corrective or preventive task.
To add work done to a corrective task, continue with Add work done to a corrective or preventive task.
To change the status of the corrective task, continue with Change the status of a corrective or preventive task.
To create a task for a corrective task, continue with Create linked corrective task for a corrective task.
To create a linked corrective task for a corrective task, continue with Create linked corrective task for a corrective task.